Ascend MultiVoice Gateway Guía de usuario descargar pdf (Pagina 149)

Configuring IP Routing

Configuring IP routes and preferences

MultiVoice Gateway for the MAX— User’s Guide Preliminary November 23, 1998 8-19

Active=Yes

Dest=0.0.0.0/0

Note: The name of the first IP Route profile is always Default, and its destination is

always 0.0.0.0 (you cannot change these values).

2 Specify the router to use for packets with unknown destinations. For example:

Gateway=10.9.8.10

3 Specify a metric for this route, the route’s preference, and whether the route is private. For

example:

Metric=1

Preference=100

Private=Yes

4 Close the IP Route profile.

Defining a static route to a remote subnet

If the connection does not enable RIP, the MultiVoice Gateway does not learn about other

networks or subnets that might be reachable through the remote device, such as the remote

network shown in Figure 8-6.

Figure 8-6. Two-hop connection that requires a static route when RIP is off

To enable the MultiVoice Gateway to route to site C without using RIP, you must configure an

IP Route profile similar to the following example:

Ethernet

Static Rtes

Name=SITEBGW

Active=Yes

Dest=10.4.5.0/22

Gateway=10.9.8.10

Metric=2

Preference=100

Private=Yes

Ospf=Cost=1

ASE-type=Type1

ASE=tag=c0000000

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 277 278

Sin comentarios

Ascend MultiVoice Gateway Guía de usuario Pagina 149