Ascend Pipeline Guía de usuario descargar pdf (Pagina 92)

IP Address Management

Connecting to a local IP network

Pipeline User’s Guide Preliminary January 30, 1998 3-3

Assigning the Ethernet interface IP address

The Pipeline Ethernet interface must have a unique IP address that is consistent

with the addresses of other hosts and routers on the same network.

To assign the Pipeline an IP address on the Ethernet:

Open the Ethernet > Mod Config > Ether Options menu.

Enter the IP address for the Ethernet interface in IP Adrs.

For example:

IP Adrs=10.2.3.1

Close and save the profile.

After you have configured the IP address, you can Ping the Pipeline from a host

to verify that it is up and running on the network. (How to use the Ping command

is described in “Using Ping to verify the address” on page 3-6.)

Creating a subnet for the Pipeline

On a large corporate backbone, administrators often configure subnets to increase

the network address space, segment a complex network, and control routing in

the local environment. For example, suppose the main backbone IP network is

10.0.0.0, and supports a router at 10.0.0.17.

Figure 3-1. Creating a subnet for the Pipeline

You can place the Pipeline on a subnet of that network by entering a subnet mask

in its IP address specification, for example:

Open the Ethernet > Mod Config > Ether Options menu.

Enter the IP address for the Ethernet interface in the IP Adrs field.

For example:

WAN

10.0.0.0

10.0.0.17

10.2.3.1/24

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 320 321

Sin comentarios

Ascend Pipeline Guía de usuario Pagina 92